Identifying and Correcting Common Nutrient Deficiencies in Cotton
Cotton leaves often tell you when the crop is hungry. Yellow lower leaves, red patches, scorched edges or heavy shedding of squares can all point to a missing nutrient, and catching these signs early can save both the flowers and the bolls.
This guide explains how to spot the common nutrient deficiencies in cotton, what each one looks like, and how farmers can correct it with soil application and foliar sprays. A soil test is still the best starting point, and this guide on soil testing and nutrient planning for cotton explains how to plan it.
Where Symptoms Appear First
The position of the symptom on the plant is the first clue. Nutrients that move inside the plant show up on older leaves first, while those that do not move show up on new growth.
Where You See It First
Likely Nutrient
Older, lower leaves
Nitrogen, phosphorus, potassium, magnesium
Young, top leaves
Sulphur, zinc, iron, manganese, calcium, boron
Squares, flowers and bolls
Boron, zinc, potassium
Major Nutrient Deficiencies in Cotton
Nutrient
Symptoms
How to Correct
Nitrogen (N)
Older leaves turn pale yellow, starting from the tip; plants stay short with small leaves and few fruiting branches
Apply the recommended nitrogen in splits, and spray 1% urea (10 g per litre of water) or 2% DAP where yellowing appears
Phosphorus (P)
Plants look dark green but stunted, with small leaves, a reddish tinge on older leaves and late flowering and boll maturity
Give the full phosphorus dose at sowing, and spray 2% DAP (20 g per litre of water) during flowering and boll development
Potassium (K)
Older leaves turn yellow between the veins, edges scorch brown and curl down, leaves droop, and bolls stay small and may not open fully
Spray 1% potassium chloride (10 g per litre of water) weekly until symptoms clear, or 2% potassium nitrate (13:0:45) from flower initiation
Secondary Nutrient Deficiencies
Nutrient
Symptoms
How to Correct
Magnesium (Mg)
Yellowing between the veins while veins stay green, leaves cup and may turn reddish purple and drop early
Apply magnesium sulphate at 20 kg per hectare as a basal dose in deficient soils, and spray 1% magnesium sulphate (10 g per litre of water)
Sulphur (S)
Young top leaves turn pale green to yellow, including the veins; plants look small and spindly
Use sulphur containing fertilizers such as gypsum, single super phosphate or ammonium sulphate at sowing on deficient soils
Calcium (Ca)
Young leaves crinkle and may yellow between the veins; root growth is poor and plants carry few fruiting forms
Apply gypsum at about 50 kg per hectare, or lime in acidic soils as advised after a soil test
Micronutrient Deficiencies
Nutrient
Symptoms
How to Correct
Zinc (Zn)
Yellowing and bronzing between the veins, small malformed leaves with long pointed tips, bunched (rosette) growth and shedding of squares and flowers
Apply zinc sulphate at 50 kg per hectare as a basal dose, or spray 0.5% zinc sulphate (5 g per litre of water) at 45, 60 and 75 days after sowing
Boron (B)
Short leaf stalks with dark green rings, crinkled leaves, dying shoot tips, heavy shedding of squares and young bolls, and bolls with dark bases or flat sides
Spray boric acid at about 1 to 2 g per litre of water, twice at flowering and boll development; avoid excess boron, as too much can harm the crop
Iron (Fe)
Young top leaves turn yellow while the veins stay green, often after irrigation
Spray 0.5% ferrous sulphate (5 g per litre of water)
Manganese (Mn)
Leaves turn light green to yellow with green veins and a mottled look, without dead spots
Spray manganese sulphate at about 5 g per litre of water, as advised locally
Boron and zinc deficiencies are common on light, sandy and calcareous soils.
Leaf Reddening in Cotton
Leaf reddening is one of the most common problems in Bt cotton, usually seen from boll formation onwards. It is mainly linked to low nitrogen and magnesium in the leaves, and it gets worse with cool nights, water stress, waterlogging and a heavy boll load that draws nutrients away from the leaves.
Situation
What to Apply
Leaf reddening in standing crop
A spray of 0.5% magnesium sulphate, 1% urea and 0.1% zinc sulphate on the 50th and 80th day after sowing
Reddening at full bloom
Two sprays of 1% magnesium sulphate at a 15 day interval, at full bloom and boll development
Reddening caused by sucking pests can look very similar, so check the underside of leaves for jassids before spraying nutrients. This guide on controlling jassids in cotton explains the signs.
Deficiency or Something Else?
Problem
How to Tell It Apart
Jassid damage
Leaf edges turn brick red, leaves curl downwards, and small green nymphs are seen on the underside
Leaf curl virus
Small vein thickening on young leaves, cupping and curling, and leaf like outgrowths under the leaf
Para wilt
Sudden drooping of healthy plants after rain or irrigation that follows a dry spell, with the roots still intact
Nematodes
Patchy stunting and yellowing in the field, with galls or damaged roots when plants are pulled out
When in doubt, compare symptoms with a soil test report. You can check your soil details on the Soil Health Card portal.
Product Recommendation:
Micronutrient
Multiplex BTC Cotton Micro Nutrient
Multiplex Swarna Zn (Zinc EDTA 12%)
Tata Rallis Solubor 20% Boron
Secondary Nutrient
Multiplex Multimag (Magnesium Sulphate 9.5%)
Water Soluble Fertilizer
Utkarsh NOP 13:00:45
Utkarsh MAP 12:61:00
Biofertilizer
Tapas VAM SP
Arihant Potagrip
Frequently Asked Questions
1. Why are my cotton leaves turning red?Red leaves in cotton are mostly linked to low nitrogen and magnesium, often with cool nights or water stress, but jassid damage can look similar.
2. Which deficiency causes yellowing of lower cotton leaves?Yellowing of older, lower leaves usually points to nitrogen deficiency, and yellowing between veins on older leaves can point to potassium or magnesium.
3. What causes square and boll shedding in cotton?Boron and zinc deficiency are common nutrient causes, along with water stress and pest attack.
4. How can zinc deficiency be corrected in cotton?Apply zinc sulphate at 50 kg per hectare as a basal dose, or spray 0.5% zinc sulphate at 45, 60 and 75 days after sowing.
5. Which spray is used for leaf reddening?A spray of 0.5% magnesium sulphate, 1% urea and 0.1% zinc sulphate on the 50th and 80th day after sowing is commonly advised.
6. Can too much boron harm cotton?Yes, excess boron can be toxic, so use it only at the recommended dose.
7. How do I confirm a nutrient deficiency?Check where the symptoms appear on the plant, rule out pests and diseases, and confirm with a soil test or Soil Health Card report.
Also Read
Cotton NPK Requirement, Dose Per Acre and Deficiency Symptoms
Micronutrient Management for Healthy Cotton Growth
Integrated Nutrient Management (INM) in Cotton
Disclaimer: Nutrient deficiency symptoms in cotton can look alike and may also be caused by pests, disease or weather stress. Doses here are general guidance and can change with soil, variety and irrigation, so confirm with a soil test and local agriculture expert before applying.